Usage guide for Compositing with Carbon Basic Positioning Controls Vectors
From left to right:
Color controls - select the color and line thickness.
"solid", "Set Fill Color", "No Fill", and "Alt Fill" are disabled as this is not a closed figure.
Direction - sets the initial direction of the vector away from the origin.
Curvature - sets the amount of curvature, may be zero for a straight line.
Radius / Circumference - for non-zero curvature determines if the size sets the radius or circumference.
When animating the curvature in radius mode the line will grow in a circular motion with a
constant radius. Conversely when in circumference mode the line will have a constant length,
increasing the curvature cause the radius to be reduced, tightening the circle.
Shape - top button stretches vertically, bottom button shrinks vertically. Left button
shrinks horizontally, right button stretches horizontally. The center button sets the
height to the width for a symetrical shape.
Note: vertical and horizontal are referenced to the unrotated frame. Rotating the frame
rotates these axes, so at 90 degrees "vertical" becomes horizontal. Frame rotation is specified
in the "Blending" tab.
Frame angle - the entire shape is rotated. First elongate one dimension with the shape
control (above) then rotate the shape - the elongation rotates.
Alignment - designates the "hot spot" of the shape.
Readouts - these display the 5 values used for drawing. Mostly used for debugging, but also
useful for duplicating another line.
Size - controls the length/circumference/radius of the generated vector.
Position - this controls the location of the other end of the line.
Mouse actions:
there are no mouse actions for vectors.